An out of the blue request from SWMBO to tidy up the walk in robe. The storage unit is approximately 1800 mm high and 900 mm wide with a shelf depth of 295 mm. In order to save time I decided to build the storage unit out of precut material all the sheets are 295mm wide. I bought melamine covered particle board 3 pieces at 1800 mm and 7 pieces at 1200mm. A sheet of 3mm MDF serves as the back of the storage unit.
Cutting was straight forward 2 of the 1200mm boards were docked at 900 for the top and bottom. One 1800mm board was cut to 1768 as the centre divider. The carcass was assembled on floor with the bottom top and sides assembled first. The storage unit was screwed together with 32mm 8 gauge chipboard screws. The divider was put in next and followed by the shelves.
I measured the width of the shelves after the carcass was constructed to ensure accuracy. Two offcuts of melamine was used to space the shelves at 295mm. This saved time as I did not have to measure and mark for each shelf. On one side I had to use pocket holes to attach the shelves to the central divider. This was not so successful because some of the pocket hole screws pushed through the adjoining shelf. I did this because I wanted a single piece in the middle.
I did try an model the unit in Sketchup prior to construction but a pencil and paper was a much quicker way to draw up plans. The unit is now installed and awaiting the arrival of clothes.